home about us tech tips faq employment what's new contact
  Home > Tech Tips

 

Tech Tips


Use this comprehensive information library whenever you need helpful hints from car repair professionals. Whether you are a professional or a DIY mechanic, you’re sure to find the tips you need to insure a job well done. Click here to go back to the previous page any time during your search.

 

Electrical System

Types of Abnormal Spark Plug Combustion

PRE-IGNITION

  • Defined as: ignition of the air/fuel mixture before the pre-set ignition timing mark
  • Caused by hot spots in the combustion chamber...can be caused (or amplified) by over advanced timing, too hot a spark plug, low octane fuel, lean air/fuel mixture, too high compression, or insufficient engine cooling.
  • A change to a higher octane fuel, a colder plug, richer fuel mixture, or lower compression may be in order.
  • You may also need to retard ignition timing, and check vehicle's cooling system.
  • Pre-ignition usually leads to detonation; pre-ignition and detonation are two separate events.

DETONATION

  • The spark plug's worst enemy! (Besides fouling)
  • Can break insulators or break off ground electrodes
  • Pre-ignition most often leads to detonation
  • Plug tip temperatures can spike to over 3000°F during the combustion process (in a race motor).
  • Most frequently caused by hot spots in the combustion chamber. Hot spots will allow the air/fuel mixture to pre-ignite. As the piston is being forced upward by mechanical action of the connecting rod, the pre-ignited explosion will try to force the piston downward. If the piston can't go up (because of the force of the premature explosion) and it can't go down (because of the upward motion of the connecting rod), the piston will rattle from side to side. The resulting shock wave causes an audible pinging sound. This is detonation.
  • Most of the damage that an engine sustains when "detonating" is from excessive heat.
  • The spark plug is damaged by both the elevated temperatures and the accompanying shock wave or concussion.

MISFIRES

  • A spark plug is said to have misfired when enough voltage has not been delivered to light off all fuel present in the combustion chamber at the proper moment of the power stroke (a few degrees before top dead center).
  • A spark plug can deliver a weak spark (or no spark at all) for a variety of reasons...defective coil, too much compression with incorrect plug gap, dry fouled or wet fouled spark plugs, insufficient ignition timing, etc.
  • Slight misfires cause a loss of performance for obvious reasons (if fuel is not lit, no energy is being created).
  • Severe misfires will cause poor fuel economy, poor driveability, and can lead to engine damage.

FOULING

  • Will occur when spark plug tip temperature is insufficient to burn off carbon, fuel, oil or other deposits.

  • Will cause spark to leach to metal shell...no spark across plug gap will cause a misfire.

  • Wet-fouled spark plugs must be changed...spark plugs will not fire.

  • Dry-fouled spark plugs can sometimes be cleaned by bringing engine up to operating temperature.

  • Before changing fouled spark plugs, be sure to eliminate root cause of fouling.

 

Go back